P28C9
Clutch A Motor Overspeed
P28C9 is stored when the clutch A motor turns faster than the controller considers plausible for the pressure it is asked to hold. Because the pump in such actuators delivers oil straight into the closed clutch circuit, the motor should slow down once pressure is reached; if it keeps racing, the oil is escaping or the pump is not loaded. Likely reasons are a leaking clutch piston seal, air drawn in at low fluid level, or a broken coupling between motor shaft and gerotor so that the motor spins free. A faulty rotor position signal can also fake a high speed, which is why P28CB/P28CC deserve a look first. P28CA is the opposite case. No carmaker publishes limits for P28C9.
Possible causes
- Oil escaping from the clutch A pressure circuit, e.g. worn piston seal high
- Pump drawing air because of low fluid level or clogged suction filter medium
- Broken drive between motor shaft and gerotor rotor low
- Faulty motor position signal reporting too high a speed low
Symptoms
- Clutch A slips or fails to transmit full torque
- Transmission warning and restricted gear choice
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28C9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.