P28C8
Clutch A Pump Motor Performance
P28C8 concerns the motor-and-pump unit of clutch A as a whole: the controller sees that the delivered result, typically the clutch pressure reported by the sensor or the motor effort needed to reach it, does not fit the command. In on-demand designs the gerotor pump is connected straight to the clutch cylinder, so pressure follows pump speed directly; a Hyundai-backed EVS32 study modelled exactly this arrangement and its energy saving. A pump clogged by particles, a worn gerotor set, internal leakage at the piston seals or low oil level make the pump work harder or fall short. No manufacturer documents P28C8 itself in public; Stellantis blames debris jamming the actuator pump for the related P28C7 on the 7HDT300.
Possible causes
- Clutch A pump obstructed by abrasion particles high
- Internal leakage at the clutch A piston or pressure line seals medium
- Worn gerotor set reducing delivery medium
- Low transmission fluid level so the pump draws air low
Symptoms
- Slipping or delayed engagement of clutch A
- Transmission warning, gears on clutch A may be locked out
- Audible whine from the actuator under load
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28C8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.