P28C6
Clutch A Motor Phase U-V-W Circuit/Open
P28C6 is the general circuit code for the three-phase supply of the clutch A motor and is set above all when a phase carries no current although the controller drives it, i.e. an open line. A brushless motor needs all three windings to produce torque; with one missing it stalls or runs roughly, and the gerotor pump behind it can no longer build the oil pressure that engages clutch A. Getrag fitted such ferrite motors as common parts for clutch actuation and shift drums in its pump-actuated DCT family. Typical faults are a backed-out terminal, a cracked solder joint in the actuator, or a broken wire near a moving bracket. P28C4/P28C5 instead describe a voltage pulled low or high. No manufacturer documents P28C6 publicly with values.
Possible causes
- Terminal pushed back or loose in the clutch A motor connector high
- Cracked solder joint or winding connection inside the actuator medium
- Phase wire broken at a bend or bracket medium
Symptoms
- Clutch A does not engage, affected gears unavailable
- Transmission warning and possibly MIL
- Fault may come and go with vibration or temperature
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28C6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.