OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28C5

Clutch A Motor Phase U-V-W Circuit High

With P28C5 the controller finds one or more phases of the clutch A motor sitting higher than the switching pattern allows, as if a lead were tied to battery voltage. The motor in question is the brushless drive of an on-demand pump actuator: Getrag introduced this concept with the 7DCT300, where one motor per clutch turns a gerotor pump and the pump pressure itself closes the clutch. Causes on the high side are a phase touching a supply wire in the harness, moisture bridging pins in the connector, or an output transistor that no longer switches off. Unlike P28C4 the fault points away from ground. Thresholds are not published by any manufacturer. The transmission typically drops clutch A and runs on the remaining shaft.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / C5

Possible causes

  • Motor phase lead shorted to a supply line in the harness high
  • Moisture or corrosion bridging pins at the actuator connector medium
  • High-side switch in the controller that no longer turns off low

Symptoms

  • Warning lamp for the transmission and stored DTC
  • Half of the gear set unavailable, vehicle continues with reduced choice
  • Clutch A may not open or close on command

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28C5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication