P28C2
Ion Sense Module Supply Voltage High
P28C2 is stored when the voltage feeding the ion sense module exceeds its upper limit. Since the module derives its measuring and, in cassette designs, its ignition voltages from this feed, an excessive input can raise the bias across the plugs, push signals toward the top of their range and stress the converter inside. The cause is rarely the module: a failing alternator regulator, a jump start from a 24 V source or a poor ground at the module that makes the measured difference look larger are more typical. Saab's published ignition diagnostics have no overvoltage check at all, only the loss-of-supply codes, so there is no maker analogue for this case; the code follows the CARB demand to check inputs for out-of-range values. No manufacturer documents P28C2. P28C0 and P28C1 are the open and low faults.
Possible causes
- Alternator voltage regulator letting the system voltage rise too high high
- Jump start or charger with excessive voltage (e.g. 24 V) medium
- Poor module ground distorting the voltage reading medium
- Faulty voltage measurement inside the module low
Symptoms
- Stored overvoltage code, often together with P0563
- Flickering or unusually bright lamps, battery gassing
- Erratic misfire or knock reports on several cylinders
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P28C2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2003/2-engine/trionic-t7-v6/technical-description/ignition-discharge-modules
- saabwisonline.com/9-3-9440/2009/3-electrical-system/wiring-harness-and-components/control-module/technical-description/ionization-detection-module-740