OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28C0

Ion Sense Module Supply Voltage Circuit

P28C0 points to a fault in the power feed of the module that conditions ion signals – typically an open fuse, relay contact or wire, so the module is not powered at all. On Saab's Trionic T8 that module receives battery voltage via the main relay and its ground from a body point, and on the older T7 the ignition cassette took the same route. Saab's nearest code, P1310 (bank 2: P1320), required a turning crankshaft and more than 6 V at the main relay, then flagged the fault when every trigger output stayed under 2 V for one second. Saab cut fuel in response, on the V6 for every cylinder although just one cassette had failed, yet treated it as Type III without a warning lamp. No manufacturer documents P28C0 itself. P28C1 and P28C2 cover a supply that is present but too low or too high.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / C0

Possible causes

  • Blown fuse in the ion sense module feed high
  • Main relay not switching through or burnt contact medium
  • Open supply wire or loose ground point of the module medium
  • Internal fault in the module's power stage low

Symptoms

  • Engine cranks but does not start, or cuts out while driving
  • Ion-based misfire and knock detection lost on all cylinders
  • Warning lamp behaviour depends on the manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P28C0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication