P28BC
Cylinder 12 Ion Current Sense Circuit
P28BC covers a wiring-level failure in the ion measuring path of cylinder 12 that keeps a valid signal from arriving, typically an open wire or a connector without contact. Cylinder 12 is the last one on a V12 or W12; no such engine with ion sensing is publicly known, and no manufacturer documents P28BC. On Saab's Trionic T8 each measuring channel needs two inputs at the detection module: the ion line from the coil and the ignition trigger of the same cylinder, which tells the module when to start listening. A break in either can leave the channel silent. With that, misfire counting and knock evaluation for cylinder 12 stop. The coil's primary circuit is a separate code, P0362. P28BD covers implausible signals, P28BE and P28BF the voltage levels.
Possible causes
- Open ion signal wire or connector at coil 12 high
- Ignition trigger for cylinder 12 not reaching the detection module medium
- Measuring stage of coil 12 dead medium
- Cylinder 12 channel of the evaluation module faulty low
Symptoms
- MIL on with a circuit fault stored for cylinder 12
- No combustion feedback from cylinder 12
- Engine may run with reduced ignition advance
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P28BC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-3-9440/2009/3-electrical-system/wiring-harness-and-components/control-module/technical-description/ionization-detection-module-740
- saabwisonline.com/9-3-9440/2006/2-engine/4-cylinder-petrol/engine-management-system-trionic-t8/technical-description/ionization-current-measurement