OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28BA

Cylinder 11 Ion Current Sense Circuit Low

P28BA means the cylinder 11 ion reading has fallen below its lower limit. Between sparks a bias voltage sits across the electrodes – 80 V on Saab's T7 – and burning gas lets a current flow that pulls this voltage down in proportion to pressure and temperature. If a fault drains the bias to ground, the evaluator registers the same collapse permanently: a sense wire chafed through, a plug insulator coated with conductive deposits, or water in the boot. Saab's manual notes that a combustion signal shorted to ground produced no dedicated code there, only misfire codes, so a separate low-signal code is a later refinement. No manufacturer documents P28BA, and no ion-sensing twelve-cylinder engine is publicly known. P28BB is the high-side fault, P28B8 the open circuit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / BA

Possible causes

  • Ion signal wire of cylinder 11 chafed and touching ground high
  • Conductive deposits on the cylinder 11 plug insulator medium
  • Moisture or a carbon track in the cylinder 11 plug boot medium
  • Bias voltage generation in coil 11 failed low

Symptoms

  • MIL on with a low ion signal stored for cylinder 11
  • Misfire code P0311 possible although the engine runs smoothly
  • Power slightly reduced by conservative timing

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P28BA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication