OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28B8

Cylinder 11 Ion Current Sense Circuit

P28B8 is the general circuit code for ion sensing on cylinder 11: the evaluation electronics receive nothing usable from that cylinder, most often because the line from coil 11 is broken or its connector has lost contact. Eleven cylinders only occur on V12 and W12 engines, and none of them with ion sensing is publicly described; no manufacturer documents P28B8. The layout such a code presumes exists on Saab's Trionic T8, whose detection module has a dedicated ion input for every coil. Losing it leaves the engine computer blind to misfire and knock on that cylinder, and on T8, which has no camshaft sensor, ion pulses also serve to find the firing order. P0361 concerns the primary side of coil K, not the measuring path; P28B9 to P28BB cover the range and level faults.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / B8

Possible causes

  • Loose, corroded or pushed-back pin in the cylinder 11 coil connector high
  • Broken ion signal wire between coil 11 and the evaluation module medium
  • Measuring stage inside coil 11 failed medium
  • Cylinder 11 input of the evaluation module damaged low

Symptoms

  • MIL on with a circuit fault stored for cylinder 11
  • Misfire and knock detection for cylinder 11 no longer available
  • Cautious ignition timing with slightly reduced power

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P28B8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication