P28B7
Cylinder 10 Ion Current Sense Circuit High
P28B7 means the ion signal of cylinder 10 is stuck above its valid window. The usual suspects are a sense lead shorted to a supply or to a neighbouring ignition circuit, breakdown inside coil 10 that lets spark energy into the measuring path, and a poor ground at the evaluation side that shifts the reference upward. A falsely high signal could pass as continuous combustion or as permanent knock, so the engine computer typically discards it and retards timing on that cylinder for safety. Saab's later T8 module, which processes the ion signal of each coil on its own input pin, shows the cylinder-selective layout such a code assumes. No manufacturer documents P28B7 publicly. The low-side fault is P28B6, module supply problems are P28C0 to P28C2.
Possible causes
- Cylinder 10 sense lead shorted to a supply or adjacent ignition circuit high
- Internal breakdown in coil 10 medium
- Poor ground at the evaluation side low
Symptoms
- MIL with high ion reading on cylinder 10
- Timing on cylinder 10 retarded for safety
- Misfire on cylinder 10 may be masked
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P28B7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-3-9440/2009/3-electrical-system/wiring-harness-and-components/control-module/technical-description/ionization-detection-module-740
- saabwisonline.com/9-3-9440/2006/2-engine/4-cylinder-petrol/engine-management-system-trionic-t8/technical-description/ionization-current-measurement