P28B6
Cylinder 10 Ion Current Sense Circuit Low
P28B6 is set when the cylinder 10 ion reading is persistently too low. The measuring bias that should sit across the gap between sparks is missing or being drained: a coil 10 whose bias generator has failed, conductive deposits bridging the plug insulator, a wet boot, or a sense wire with insulation damage touching ground. Saab's T7 applied 80 V for this purpose, the later T8 about 120 V; either way, a short to ground collapses it. The engine computer then lacks combustion confirmation for cylinder 10, may log P0310 and usually falls back to cautious timing. No manufacturer documents P28B6 publicly, and no ion-sensing engine with ten or more cylinders is known. The high-side code is P28B7.
Possible causes
- Conductive deposits bridging the cylinder 10 plug insulator high
- Cylinder 10 sense wire with damaged insulation touching ground medium
- Bias generator of coil 10 failed medium
- Wet plug boot on cylinder 10 low
Symptoms
- MIL with low ion reading on cylinder 10
- P0310 may be stored as well
- Cautious ignition timing, less pulling power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P28B6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2003/2-engine/trionic-t7-4-cyl/technical-description/ignition-discharge-module
- saabwisonline.com/9-3-9440/2006/2-engine/4-cylinder-petrol/engine-management-system-trionic-t8/technical-description/ionization-current-measurement