P28B4
Cylinder 10 Ion Current Sense Circuit
P28B4 is the basic circuit code for the ion current measurement of cylinder 10; typically the line from coil 10 to the evaluation module is interrupted or the coil's measuring stage is dead. Ten cylinders mean a V10 at minimum, where this is the last cylinder in the numbering, or a V12 or W12, where it is not. No production engine of that size with ion sensing is publicly described, and no manufacturer documents P28B4. Saab's systems illustrate the stakes: without the ion signal, misfire counting and cylinder-selective knock control lose their input, and the T7 V6 even cut fuel to every cylinder once a single discharge module lost its supply. Start at coil 10, plug and connector; P28B5, P28B6 and P28B7 are the range and level faults.
Possible causes
- Open line between coil 10 and the evaluation module high
- Measuring stage of coil 10 dead medium
- Corroded terminals at the coil 10 connector medium
Symptoms
- MIL with ion circuit fault for cylinder 10
- Cylinder 10 excluded from misfire and knock evaluation
- Possible power reduction through protective timing
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P28B4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.