P28B2
Cylinder 9 Ion Current Sense Circuit Low
P28B2 is stored when the ion current measured at cylinder 9 remains under its lower plausibility limit. In an ion-sensing ignition each coil both fires the plug and supplies the measuring voltage, so a coil 9 with a weak bias stage, a cracked plug insulator or a signal wire grounded in the harness all reduce the current reaching the evaluator. Because the evaluation can hardly tell a dead circuit from a cylinder that does not burn, misfire code P0309 frequently accompanies it. On Saab's four-cylinder T7, a ground short on a combustion line triggered no special code at all, only misfire reports. No manufacturer publicly documents P28B2, and no ion-sensing V10 is known. P28B3 is the high fault, P28B1 the plausibility fault.
Possible causes
- Cylinder 9 signal wire grounded in the harness high
- Cracked insulator on the cylinder 9 plug medium
- Coil 9 with weak bias stage medium
Symptoms
- MIL with low ion reading on cylinder 9
- P0309 often stored at the same time
- Reduced power under load
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P28B2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-3-9440/2006/2-engine/4-cylinder-petrol/engine-management-system-trionic-t8/technical-description/ionization-current-measurement
- saabwisonline.com/9-5-9600/2003/2-engine/trionic-t7-4-cyl/technical-description/ignition-discharge-module