OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28AE

Cylinder 8 Ion Current Sense Circuit Low

P28AE stands for an ion reading from cylinder 8 that stays too low or near zero. Either the measuring voltage never reaches the plug, because the coil's bias stage or its supply has failed, or it drains away to ground through a damaged signal wire, a wet plug well or a tracked boot. With ion sensing the plug doubles as knock and combustion sensor, so a dead reading also takes knock protection for cylinder 8 away and the engine computer tends to fall back on retarded timing. A supply fault affecting the whole module would rather appear as P28C0 to P28C2 than as a single-cylinder code. No manufacturer documents P28AE in public; an eight-cylinder ion-sensing engine is not described. P28AF is the high-side fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / AE

Possible causes

  • Water or oil in the cylinder 8 plug well high
  • Damaged cylinder 8 signal wire shorted to ground medium
  • Bias stage of coil 8 not producing measuring voltage medium

Symptoms

  • MIL lit with a low ion reading for cylinder 8
  • Knock protection of cylinder 8 lost, timing retarded
  • Possible misfire report for cylinder 8

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P28AE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication