OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28AC

Cylinder 8 Ion Current Sense Circuit

P28AC flags a general electrical fault in the ion current path of cylinder 8, typically an open connection, so no usable signal reaches the evaluation electronics. On a V8 this is the highest-numbered cylinder, on V10 and V12 engines a middle one; which bank it sits on depends on the maker's numbering. A cylinder-specific code presumes one input per coil, as in the CDM of Saab's later Trionic T8, which receives a separate ion line from each of the four coils. Older T7 modules merged cylinders into shared detectors and could not name a single one. No manufacturer documents P28AC, and no eight-cylinder ion-sensing engine is publicly known. Check coil 8, its plug, connector and wiring first; range and level faults are P28AD, P28AE and P28AF.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / AC

Possible causes

  • Loose or corroded connector in the cylinder 8 ion line high
  • Measuring stage of coil 8 failed medium
  • Broken conductor between coil 8 and the evaluation module medium
  • Cylinder 8 input of the evaluation module defective low

Symptoms

  • MIL with a circuit fault stored for cylinder 8
  • No misfire or knock assessment for cylinder 8
  • Engine may run with conservative timing and lower power

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P28AC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication