P28A7
Cylinder 6 Ion Current Sense Circuit High
P28A7 is logged when the ion signal of cylinder 6 is held above the upper limit the module accepts. A conductor in contact with battery voltage, crosstalk from the primary side of coil 6, or an evaluation stage driven into saturation are the typical electrical explanations. Saab's T7 V6 handled the comparable fault per bank: cylinder 6 belongs to bank 2, whose combustion line triggers Saab code P1324 when it stays above 5 V for 200 combustions; the knock information of that bank travels separately to engine module pin 62. A saturated channel leaves no room for the knock oscillations, so the module retards timing on cylinder 6. No manufacturer documents P28A7 publicly. The low-side counterpart is P28A6.
Possible causes
- Ion conductor of cylinder 6 touching battery voltage high
- Crosstalk from the primary side of coil 6 medium
- Evaluation stage for cylinder 6 saturated low
Symptoms
- MIL with high ion signal on cylinder 6
- Less power because of late ignition on cylinder 6
- Knock on cylinder 6 may not be detected
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P28A7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.