P28A5
Cylinder 6 Ion Current Sense Circuit Range/Performance
P28A5 points to a cylinder 6 ion signal that exists but makes no sense for the operating point: too little combustion response, a trace that jumps between cycles, or one that departs from the remaining cylinders. Since ionisation follows the actual burn, a misfiring or lean cylinder 6 can trigger it as readily as a worn plug or a wet plug well. On Saab's T7 V6 the bank 2 module evaluates the ion flow of cylinders 2, 4 and 6 for knock, sending the result to engine module pin 62, and missing combustion signals on cylinder 6 feed misfire code P0306. If the signal is unreliable, knock control tends to retard timing more often. No manufacturer publicly documents P28A5; P28A4, P28A6 and P28A7 are the electrical siblings.
Possible causes
- Spark plug of cylinder 6 worn or sooted high
- Water or oil in the plug well of cylinder 6 medium
- Poor combustion in cylinder 6 (injector, valve, compression) medium
Symptoms
- MIL, often together with P0306
- Rough running at idle or light throttle
- Hesitation under acceleration
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P28A5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.