OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28A4

Cylinder 6 Ion Current Sense Circuit

P28A4 is the general circuit code for the ion measurement of cylinder 6: the electronics get no usable signal from that plug. Only engines with six or more cylinders are affected, and among them ion sensing is rare. The V6 of Saab's 9-5 with Trionic T7 used it; there cylinder 6 is in bank 2 with 2 and 4, is triggered from engine module pin 32, and shares its start spark with cylinder 3. The V6 of the 2007 Saab 9-3 is a counterexample: its Motronic ME9 relies on two piezo knock sensors, one per bank, so no ion signal exists there at all. No manufacturer publicly documents P28A4; on an affected engine, coil 6, its wiring and the plug are checked first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / A4

Possible causes

  • Ion measuring part of the cylinder 6 coil defective high
  • Open ion signal circuit of cylinder 6 in the harness or connector medium
  • Processing input for cylinder 6 failed low

Symptoms

  • MIL with ion fault stored for cylinder 6
  • Reduced misfire and knock monitoring on cylinder 6
  • Moderate power loss from cautious timing

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P28A4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication