OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P289F

Cylinder 4 Ion Current Sense Circuit High

P289F is set when the ion measurement of cylinder 4 is held above its plausible maximum. Electrically, look for a signal conductor in contact with a supply feed, an internally leaking coil 4, or a poor ground that lifts the reference level. On Saab's T7 V6, cylinder 4 is part of bank 2 with cylinders 2 and 6; there a combustion detection line above 5 V for 200 combustions sets Saab code P1324, which needs 300 fault-free combustions to report OK. On the 2009 four-cylinder module, the ignition trigger of cylinder 4 enters on pin 1, the ion signal on pin 15. A permanently high channel hides the knock oscillations, so timing is retarded. No manufacturer publishes P289F; P289E is the low case.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 9F

Possible causes

  • Ion signal conductor of cylinder 4 touching a supply feed high
  • Internal leakage in coil 4 raising the measuring output medium
  • Poor ground lifting the reference of the cylinder 4 channel low

Symptoms

  • MIL with high ion signal on cylinder 4
  • Reduced performance from retarded ignition
  • Knock protection on cylinder 4 weakened

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P289F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication