P289E
Cylinder 4 Ion Current Sense Circuit Low
P289E means the ion signal of cylinder 4 remains below the range the module expects. A ground fault on the line from coil 4, a plug whose insulator conducts the bias voltage away, or a coil that has stopped generating that voltage are the main suspects. In Saab's T7 four-cylinder cassette, cylinders 3 and 4 share one detector that pulses engine module pin 6; Saab notes that a short to ground on such a combustion line produced only misfire codes, while an open line was flagged as P1334. A dedicated low code for cylinder 4 separates this case. Since cylinder 4 is also the start partner of cylinder 1, a dead signal can affect synchronisation. The opposite reading is P289F.
Possible causes
- Ion signal line of cylinder 4 shorted to ground high
- Spark plug insulator of cylinder 4 leaking the bias voltage medium
- Bias voltage generation inside coil 4 failed medium
Symptoms
- MIL with low ion signal on cylinder 4
- Possible start delay or misfire codes
- Power reduced by safety timing on cylinder 4
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P289E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2003/2-engine/trionic-t7-4-cyl/technical-description/ignition-discharge-module
- saabwisonline.com/9-3-9440/2006/2-engine/4-cylinder-petrol/engine-management-system-trionic-t8/technical-description/ionization-current-measurement