P289B
Cylinder 3 Ion Current Sense Circuit High
P289B signals that the ion channel of cylinder 3 sits permanently above its upper limit. A conductor touching battery voltage, a coil that couples ignition energy into its measuring output, or a lost ground reference are the usual electrical reasons. Saab shows a comparable bank-level check on the Trionic T7 V6, where cylinder 3 belongs to bank 1 together with 1 and 5: its code P1313 is set when the combustion detection line stays above 5 V for 200 combustions and clears after 300 without fault. On the 2009 four-cylinder module, cylinder 3 has trigger input pin 2 and ion input pin 8, which makes targeted voltage checks easy. No manufacturer publishes P289B. The low-side counterpart is P289A.
Possible causes
- Ion signal wire of cylinder 3 shorted to battery or supply voltage high
- Coil 3 coupling ignition energy into its measuring output medium
- Missing ground reference at coil 3 or the processing module low
Symptoms
- MIL with high ion signal fault on cylinder 3
- Knock on cylinder 3 may go undetected, so timing is retarded
- Reduced pulling power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P289B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2003/2-engine/trionic-t7-v6/fault-diagnosis-diagnostic-trouble-codes/p1313
- saabwisonline.com/9-3-9440/2009/3-electrical-system/wiring-harness-and-components/control-module/technical-description/ionization-detection-module-740