P289A
Cylinder 3 Ion Current Sense Circuit Low
P289A applies when the ion reading of cylinder 3 stays below the lower plausibility limit. Usually the signal path is pulled to ground somewhere, or the coil no longer supplies the measuring voltage of roughly 80 V that Saab's T7 cassette keeps across each gap between sparks. A cracked insulator or heavy carbon tracking on the plug can drain that voltage as well. Saab's own documentation shows why a dedicated code helps: on T7 four-cylinders a combustion signal shorted to ground produced no specific fault code at all, so synchronisation failed and only misfire codes appeared. With a stuck-low cylinder 3 signal, misfire and knock judgement for that cylinder is lost. The high-side fault is P289B.
Possible causes
- Ion signal wire of cylinder 3 chafed through to ground high
- Carbon tracking or cracked insulator on the cylinder 3 plug medium
- Coil 3 no longer builds up its measuring voltage medium
Symptoms
- MIL with low ion signal on cylinder 3
- Misfire codes or no misfire detection for cylinder 3
- Less power because timing is pulled back as a precaution
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P289A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2003/2-engine/trionic-t7-4-cyl/technical-description/ignition-discharge-module
- saabwisonline.com/9-3-9440/2009/3-electrical-system/wiring-harness-and-components/control-module/technical-description/ionization-detection-module-740