P2898
Cylinder 3 Ion Current Sense Circuit
P2898 marks a basic circuit failure in the ion current measurement of cylinder 3: the engine computer receives nothing it can evaluate from that spark plug. With ion sensing, the plug doubles as a probe, because a bias voltage across the gap drives a small current through the burning, conductive gas. On Saab's Trionic four-cylinders, cylinder 3 shares its start-up spark with cylinder 2 until synchronisation is reached, and only the combustion signal reveals which of the two really burned. The T7 version groups cylinders 3 and 4 on one detector, whose open line to the engine module Saab reports with its own code P1334. No manufacturer publicly documents P2898 itself; coil 3, its connector and the plug are the first checks.
Possible causes
- Ignition coil of cylinder 3 whose ion measuring stage has failed high
- Loose or corroded connector at coil 3 or broken ion signal wire medium
- Faulty cylinder 3 input in the ion processing module or engine module low
Symptoms
- MIL with ion fault stored for cylinder 3
- Starting may take longer while cylinder identification is uncertain
- Engine runs with cautious ignition timing and somewhat less power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2898
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-3-9440/2006/2-engine/4-cylinder-petrol/engine-management-system-trionic-t8/technical-description/ionization-current-measurement
- saabwisonline.com/9-5-9600/2003/2-engine/trionic-t7-4-cyl/technical-description/ignition-discharge-module