OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2897

Cylinder 2 Ion Current Sense Circuit High

P2897 applies when the ion current reading of cylinder 2 is stuck above the range the module accepts. Typical electrical reasons are a signal line that has contacted a supply or ignition feed, a damaged coil 2 that leaks primary voltage into its measuring output, or a missing ground at the coil that shifts the reference. Since the processing electronics compare the cylinders, a single high channel is easy to isolate: exchanging coil 2 with another position and watching whether the code follows is a quick test. On Saab's 2009 module the ignition trigger for cylinder 2 arrives on pin 10, which helps when tracing the wiring. No manufacturer documents P2897 publicly. The low case is P2896; cylinder 1 has the matching code P2893.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 97

Possible causes

  • Ion signal wire of cylinder 2 in contact with a voltage source high
  • Coil 2 leaking primary voltage into the measuring output medium
  • Poor ground connection at coil 2 low

Symptoms

  • MIL and stored cylinder 2 ion fault
  • Less power due to retarded timing on cylinder 2
  • Knock protection for cylinder 2 limited

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2897

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication