OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2896

Cylinder 2 Ion Current Sense Circuit Low

P2896 reports a cylinder 2 ion signal that remains under its lower limit. A ground short on the line from coil 2, a cracked plug insulator that drains the measuring voltage to the cylinder head, or a coil whose bias generator has failed can all produce a near-zero reading. Where several cylinders share a harness section or connector, a chafed spot can hit cylinder 2 alone if only its conductor is damaged, so the wiring along the cam cover deserves a look. On Saab's 2009 four-cylinder module the cylinder 2 ion input is pin 7, which allows measuring the line directly. No manufacturer publishes this code. Without a usable signal, misfire and knock detection for cylinder 2 lose their basis. P2897 is the high counterpart; cylinder 1 reports the same condition as P2892.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 96

Possible causes

  • Chafed ion signal wire of cylinder 2 touching ground high
  • Cracked spark plug insulator in cylinder 2 medium
  • Measuring voltage generator in coil 2 failed medium

Symptoms

  • MIL with ion fault on cylinder 2
  • Engine runs on a safe ignition map with less power
  • Misfire on cylinder 2 may not be detected

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2896

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication