P2894
Cylinder 2 Ion Current Sense Circuit
P2894 covers a general fault in the ion current circuit of cylinder 2: the processing electronics get no evaluable signal from this plug. Which physical position cylinder 2 occupies depends on the maker's numbering. On Saab's Trionic four-cylinder, cylinders 2 and 3 are fired together by waste spark during start-up, and only the ion signals tell the engine management which of the two actually burned; a missing cylinder 2 signal can thus prolong cranking. In the 2009 Saab 9-3 module, cylinder 2 has its own ion input and trigger line and feeds the second combustion signal together with cylinder 4. No manufacturer publishes P2894; checking coil 2, its wiring and the plug comes first, and swapping coils between cylinders shows whether the fault moves.
Possible causes
- Ignition coil of cylinder 2 with dead ion measurement high
- Interrupted ion signal path from coil 2 medium
- Defective cylinder 2 input in the processing module low
Symptoms
- MIL with a stored cylinder 2 ion fault
- Hard or longer starting in some cases
- Cautious ignition timing and slightly less power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2894
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-3-9440/2006/2-engine/4-cylinder-petrol/engine-management-system-trionic-t8/technical-description/ionization-current-measurement
- saabwisonline.com/9-3-9440/2009/3-electrical-system/wiring-harness-and-components/control-module/technical-description/ionization-detection-module-740