P2893
Cylinder 1 Ion Current Sense Circuit High
With P2893 the ion signal from cylinder 1 sits above its plausible ceiling. A signal line touching a supply voltage is the most direct explanation; crosstalk from the ignition primary circuit or a defective evaluation stage that saturates can show the same picture. Because knock is recognised from fast oscillations superimposed on the ion current, a signal pinned high leaves no room for that information, and the module will usually retard timing on cylinder 1 for safety. Saab's ion detection module, for instance, receives the cylinder 1 trigger on pin 9 and the matching ion input on pin 16, both of which can be checked for foreign voltage. A public manufacturer description of P2893 does not exist. Compare P2892 for the low reading and P2897 for cylinder 2.
Possible causes
- Ion signal wire of cylinder 1 shorted to a voltage source high
- Internal fault in coil 1 coupling ignition voltage into the signal medium
- Saturated input in the ion processing module low
Symptoms
- MIL with cylinder 1 ion fault
- Reduced power and possibly higher fuel consumption
- Knock may go unnoticed on cylinder 1
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2893
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.