P2892
Cylinder 1 Ion Current Sense Circuit Low
P2892 says the ion measurement of cylinder 1 delivers a signal that stays below the expected range. Electrically this points to a signal line shorted to ground or a measuring stage that no longer builds up its bias voltage; Saab, for example, applies around 120 V across the plug gap between sparks to obtain the current. A heavily fouled plug can also drag the level down by bleeding off the measuring voltage. When the reading is stuck low, the module can no longer judge combustion in cylinder 1 and typically falls back to a safe ignition map. No manufacturer has published this code; on Saab Trionic T8 engines the cylinder 1 ion line runs from coil pin 4 to the processing module. The high-side fault is P2893, the cylinder 2 equivalent P2896.
Possible causes
- Ion signal wire of cylinder 1 shorted to ground high
- Coil 1 no longer generates its measuring voltage medium
- Spark plug of cylinder 1 with leakage path through deposits medium
Symptoms
- MIL and stored fault for cylinder 1
- Noticeably less power from retarded ignition
- Possibly unreported misfires on cylinder 1
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2892
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.