P2890
Cylinder 1 Ion Current Sense Circuit
Some engines use the spark plug as a combustion sensor: between sparks a measuring voltage is applied, and the hot, ionised gas lets a small current flow whose shape reveals misfire and knock. P2890 is the basic circuit fault for this measurement on cylinder 1 – the module receives no usable ion signal from that cylinder at all. Saab built the principle into its Trionic engines: on the four-cylinder T8 the coil of cylinder 1 feeds its ion signal to a separate processing module, which also decides whether cylinder 1 or 4 is on the firing stroke, because the engine has no camshaft sensor. A dead cylinder 1 signal can therefore disturb synchronisation as well. Saab used its own codes; no manufacturer publicly documents P2890.
Possible causes
- Ignition coil of cylinder 1 with failed ion measuring stage high
- Open ion signal wire or connector between coil 1 and the processing module medium
- Faulty ion processing module or engine control module input low
Symptoms
- MIL with reduced knock and misfire monitoring on cylinder 1
- Longer cranking if cylinder identification is affected
- Retarded ignition and less power as a precaution
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2890
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.