OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P288E

Shift Fork A Actuator Control Circuit Driver Current/Temperature Too High

P288E is a self-protection code of the output stage that powers the actuator of shift fork A. The driver reports a current above its limit or an excessive chip temperature, and the module throttles or switches off that actuator. No manufacturer documents P288E publicly. Ford's DPS6 shows where such a stage sits: a motor driver chip inside the TCM, which Ford calls the ATIC, sets the current of the three-phase motor for drum A, yet Ford books faults of that chip as P2831, not P288E. Plausible triggers are a shorted winding or lead, a drum or fork that binds so the motor stalls at full current, repeated shift attempts against a blockage, and heat in the transmission housing. CARB 13 CCR 1968.2 sets the monitoring duty. With fork A out of action, 1st, 3rd and 5th may no longer engage.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 8E

Possible causes

  • Shorted winding or lead in the fork A actuator circuit high
  • Binding drum or fork stalling the actuator under full current medium
  • High transmission temperature adding heat to the driver low
  • Defective driver stage in the control unit low

Symptoms

  • Odd gears do not engage, car may start in 2nd
  • Transmission warning and limp mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P288E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication