P2889
Park Lock/Pawl Actuator Circuit Low
P2889 reports that the park lock actuator circuit sits lower than it should, as a rule because the line touches ground. Ford's 2024-25 summary pairs it with P2887_11, a short to ground, on the 8F24, 8F35/8F40 and 8F57 automatics; for the TR9070 dual-clutch unit it is called a shorted switch on the parking lock hold solenoid, meaning the switching side of the stage is pulled to ground. Chafed insulation where the harness passes brackets, moisture or corrosion in the connector and a coil shorted to its housing are typical finds. Some layouts would then energise the actuator permanently, others cannot switch it at all, so the controller blocks the function and warns the driver. Repairs start with resistance and insulation checks against ground, measured with the connector unplugged.
Possible causes
- Harness chafed through and shorted to ground high
- Moisture or corrosion in the actuator connector medium
- Actuator coil shorted to its housing medium
Symptoms
- Park lock function blocked, warning shown
- Difficulty selecting or leaving P
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2889
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.