P2888
Park Lock/Pawl Actuator Circuit/Open
P2888 flags an open circuit in the park lock actuator path: the output stage switches on but finds no load. Ford's 2024-25 OBD summary maps it, alongside P2887_13, for the 8F24, 8F35/8F40 and 8F57 front-drive automatics, and in the TR9070 dual-clutch gearbox as an open load on the parking lock hold solenoid, where it can also be reported as P2887_01. Typical findings are a broken wire or backed-out pin at the transmission connector, a burnt-out coil, or an internal break in the actuator. Depending on the design, the controller can then no longer hold or move the lock as commanded, so the car may stay in P, or the system refuses shift requests and keeps the lock applied for safety. CARB 13 CCR 1968.2 requires circuit continuity checks on electronic transmission outputs.
Possible causes
- Broken wire or backed-out terminal at the actuator connector high
- Open coil in the park lock actuator or hold solenoid medium
- Output stage in the control unit not switching low
Symptoms
- Vehicle stays in P or will not accept a gear
- Shift system warning
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2888
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.