OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2880

Engine Disconnect Clutch Actuator Circuit Low

P2880 is stored when the signal in the actuator circuit of the engine disconnect clutch stays below its permitted window. In practice this usually means a short to ground on the control side, or a feed that has lost supply voltage, so that the solenoid or actuator is either energised permanently or not at all, depending on which side is affected. The control module normally switches the output off to protect itself. No manufacturer publishes a description of this code; the circuit monitoring follows the general CARB demand that output components of the powertrain be checked for electrical faults. Whether the clutch then rests open or closed depends on its design; the Ford F-150 PowerBoost and the Audi plug-in hybrids use hydraulic clutches inside the transmission. Compare P2881 for the high side.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 80

Possible causes

  • Chafed control wire shorted to ground or housing high
  • Missing supply voltage (fuse, relay, feed wire) medium
  • Internal short in the clutch solenoid coil medium
  • Faulty output stage in the control module low

Symptoms

  • Hybrid or transmission warning lamp
  • Engine cannot be coupled, only electric driving available
  • Limp-home mode after the output is switched off

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2880

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication