P2873
Clutch B Pressure Engagement Too High
P2873 is set when clutch B is applied with more pressure than planned while it engages. In dual-clutch designs clutch B usually carries the even gears and reverse, as in Ford's DPS6 and GM's Corvette unit, so the fault tends to surface as jerky shifts into second, fourth or reverse and a hard bite when manoeuvring. Manufacturer documentation for P2873 is not public. CARB 13 CCR 1968.2 calls for functional checks of transmission controls; in GM's 2023 Corvette table the comparable high-pressure check of clutch 2 appears under P2856, classed as Type A. Worth checking are a sticking pressure control solenoid for clutch B, line pressure set too high, a sensor that over-reads, or adaptation values that have drifted.
Possible causes
- Clutch B pressure control solenoid sticking high high
- System (line) pressure above specification medium
- Drifted or reset adaptation values for clutch B medium
- Clutch B pressure sensor over-reading low
Symptoms
- Jerky shifts into even gears or reverse
- Hard bite when manoeuvring
- Warning lamp, limp mode possible
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2873
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.