P286B
Clutch A Pressure Engagement Too High
P286B means the pressure applied to clutch A during engagement exceeded the level the control unit had planned. A clutch pressed too hard closes abruptly, which shows up as a jolt, a harsh launch or a shunt through the driveline. No manufacturer documents P286B publicly; the basis is CARB 13 CCR 1968.2, which asks for functional monitoring of automatic transmission controls. GM's 2023 Corvette dual-clutch software performs a comparable check under another number: clutch 1 is reported as a Type A fault under P2855 when its measured pressure rises clearly above the model, for example more than about 1.2 bar above the hold level for 300 ms. Typical causes are a sticking pressure control valve, a sensor that reads high or adaptation values lost after a repair.
Possible causes
- Clutch A pressure control valve sticking towards high output high
- Clutch adaptation values missing or wrong after repair or software update medium
- Clutch pressure sensor reading higher than actual low
Symptoms
- Harsh launch or jolt when clutch A closes
- Clunk through the driveline during shifts
- Warning lamp, possibly limp mode
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P286B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.