P2867
Shift Fork E Position Circuit Intermittent
P2867 reports that the fork E sensor signal is present but unsteady. GM's Corvette TCM times each cycle of the digital rod 5 signal and sets the code, Type A, when the frequency drops below 1500 Hz or rises above 2500 Hz for at least 150 ms, with the same voltage and cranking exclusions as the low and high tests. So the sensor keeps pulsing, just not at a rate the module accepts. Such dropouts are usually caused by a loose pin, a chafed shield picking up interference, or a sensor beginning to fail with heat. The Mercedes 8G-DCT diagnosis list names fork E sensor faults but not this number. Unlike P2865 and P2866, the fault may come and go, so a stored code without symptoms is common at first.
Possible causes
- Loose or fretted terminal in the fork E sensor circuit high
- Damaged shielding letting electrical noise into the signal medium
- Sensor electronics failing intermittently when hot medium
Symptoms
- Sporadic warning, sometimes without noticeable effect
- Occasional lockout of fork E gears
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2867
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.