OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2866

Shift Fork E Position Circuit High

P2866 is the high-level fault of the fork E sensor input. GM's Corvette TCM, reading rod 5 as a pulse-width signal, stores it as Type A in two situations: the line delivers no pulses and stays above 3500 mV, or the duty cycle climbs past 92 %. Either must persist for 150 ms, and the check pauses during cranking or when battery or reference voltage lies outside its window. On the Mercedes 8G-DCT the matching entry P286600 is described as a short to positive of the fork E sensor. Possible reasons are a signal lead touching a supply wire, an open ground of the sensor that lets the line float up, or a sensor that latches its output. P2865 is the low counterpart; a signal that pulses at the wrong rate sets P2867 instead.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 66

Possible causes

  • Fork E signal wire touching a supply voltage wire high
  • Open ground of the fork E sensor letting the signal float high medium
  • Sensor electronics holding the output permanently high low

Symptoms

  • Gears of fork E withheld, warning shown
  • Engine lamp after a short drive

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2866

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication