OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2865

Shift Fork E Position Circuit Low

P2865 means the fork E position input is stuck low. On GM's 2023 Corvette, whose rod 5 sensor sends a pulse-width signal, the TCM runs two Type A checks under this number: no pulses at all while the pin rests below 2000 mV, or a duty cycle under 8 %, each confirmed after 150 ms. The test is suspended while cranking, outside 8.75 to 18 V battery voltage, or when the sensor reference supply leaves its band. Mercedes-Benz names P286500 on the 8G-DCT plainly as a short to ground of the fork E position sensor. Look for a signal wire grounded in the harness, a sensor with an internal short, or a missing reference voltage. The high-side counterpart is P2866, the frequency fault P2867.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 65

Possible causes

  • Fork E sensor signal wire shorted to ground high
  • Fork E sensor with internal short or failed output stage medium
  • Sensor supply missing because of an open feed low

Symptoms

  • Warning lamp with fork E gears blocked
  • Fault returns at once after clearing

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2865

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication