OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P285E

Shift Fork A Actuator Circuit High

P285E is logged when a line of the fork A actuator carries supply voltage where the module expects it to be switched low. Usual explanations are a harness short to a battery-fed wire or a low-side transistor in the module that no longer turns on; with some driver designs, an unloaded output can also read high. Ford names the code for its 2012 DPS6 dual-clutch unit as the short-to-power fault of the shift drum A motor, the drive that sets the forks for gears 1, 3 and 5, and lists it as a MIL code in its 2014 catalogue. The low-side companion is P285D, the open circuit P285B. Because a phase stuck at battery potential prevents controlled rotation, the module stops the motor and leaves the odd gears unavailable until the short is cleared.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 5E

Possible causes

  • Actuator lead shorted to a battery-fed wire in the harness high
  • Low-side driver in the transmission module not switching medium
  • Bridged pins in the actuator or module connector low

Symptoms

  • Engine lamp lit, gears 1, 3 and 5 unavailable
  • Gearbox stays in an even gear or neutral

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P285E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication