P2853
Clutch A Pressure Discharge Performance
P2853 is set when the pressure measured at clutch A falls short of what the control model predicts. GM's 2023 Corvette dual-clutch table applies it to clutch 1, the odd-gear clutch, as a Type A fault in two ways: the model expects more than 1 bar while the sensor shows under 0.5 bar for 5 s, or the measured value stays below the model by more than a calibrated margin for too long. GM labels this result a pressure discharge fault and requests recovery of the odd-side clutch. Ford's 2024 summary gives the same number to measured odd clutch pressure below target on the TR9070. A real pressure loss weakens or prevents engagement, so launch and odd gears suffer; sensor offset faults have their own codes such as P0844.
Possible causes
- Clutch A pressure control valve sticking or delivering too little high
- Leaking seal or piston ring in the clutch A circuit medium
- Low fluid level or clogged filter reducing supply pressure medium
Symptoms
- Weak or delayed launch, engine flares
- Odd gears unavailable, limp-home mode
- Warning lamp on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2853
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.