OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P284F

Shift Fork C Unrequested Movement

P284F covers drift of fork C away from its held gear. In GM's Corvette software this is rod 3, which sits on the shaft of the even clutch; the check compares the rod position with the learned point for the gear that the even clutch speed and the output speed confirm, and sets a Type A code once the wide limit is exceeded long enough or the drift correction keeps firing. The repair routine that follows works on the even shaft. Ford is inconsistent: its 2024 TR9070 table for the four rod sensors lists rod 3 drift as P277E, whereas a second table in the same summary, sorted by shift rod, gives P284F. Mechanical causes are the same as for the other forks, though only the gears of fork C are withdrawn while the fault is active.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 4F

Possible causes

  • Residual pressure on the fork C actuator from a leaking valve high
  • Rod 3 sensor reading offset so the fork appears to move medium
  • Worn detent or synchronizer parts at fork C low

Symptoms

  • Even-shaft gear disengages unexpectedly
  • Shift flare or jerk while cruising
  • Warning lamp with stored code

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P284F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication