P284E
Shift Fork B Unrequested Movement
P284E reports that fork B drifted while no shift was asked for. GM's 2023 Corvette dual-clutch table describes the test on rod 2 in detail: with no actuating force applied, the measured position must stay inside wide limits around the learned point of the gear verified as engaged by clutch-shaft and output speed readings; leaving them for 500 ms is a fault. The code also sets if the drift correction, which acts on narrower limits, triggers ten times or stays active for over 5 s. The DTC is Type A and launches a resynchronization routine on the odd shaft. Ford's TR9070 documentation from 2024 assigns P284E to drift of shift rod 2, and Mercedes-Benz lists P284E00 for its 8G-DCT as fork B moving on its own.
Possible causes
- Synchronizer pressure valve for fork B leaking and pushing the rod high
- Weak detent or worn gear dog teeth on fork B gears medium
- Outdated learned engaged positions medium
Symptoms
- Gear on the odd shaft pops out or is re-engaged with a jolt
- Warning lamp, possible limp-home mode
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P284E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.