OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P284D

Shift Fork A Unrequested Movement

P284D means fork A has crept away from the position of the gear it is supposed to hold, without any shift being commanded. Several makers use it. Audi bulletin 2078846 covers 2025 A5 and Q5 models with the DL382 and DL552 dual-clutch boxes: the cluster reports a drive system fault with limited performance, and if guided fault finding finds no cause, the gear position distance sensors G487 to G490 are calibrated ten times in a row; a later revision adds a combined software update. Mercedes-Benz names P284D00 for its 8G-DCT, and Ford's 2024 summary links it to rod drift of shift rod 1 in the TR9070. GM's Corvette software runs it as a Type A drift check on rod 1, after which a synchronizer recovery routine starts on the odd shaft.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 4D

Possible causes

  • Gear position sensors poorly calibrated (Audi DL382/DL552) high
  • Transmission software needing an update medium
  • Leaking fork A actuator or weak detent letting the rod creep medium

Symptoms

  • Message about a drive system fault with limited performance
  • First or seventh gear cannot be selected (Audi report)
  • Gear may jump out under load

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P284D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication