P2849
Shift Fork A Stuck
P2849 says that fork A did not travel when the module ordered it to, so its gear could not be put in or taken out. The reading may be valid; the fork itself is not following the command. No manufacturer publishes a strategy for P2849, and the code relies on the CARB 13 CCR 1968.2 rule that transmission components be checked for proper function. GM's 2023 Corvette table shows how a frozen rod is found: an intrusive integrity routine nudges each rod in both directions through its synchronizer valves and expects more than 100 µm of travel. GM, however, charges a rod that never moves to its position sensor and logs it under the first rod's consistency code P2832. Causes range from a seized rod or broken fork to a failed actuator.
Possible causes
- Shift rod of fork A seized in its bore or blocked by debris medium
- Fork A actuator or its control valve not moving the rod high
- Broken fork or damaged synchronizer sleeve jamming the shift low
Symptoms
- Gear of fork A will not engage or stays engaged
- Limp-home mode with limited gears
- Clunking or grinding during shift attempts
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2849
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.