P2844
Shift Fork D Position Circuit Intermittent
P2844 points to a fork D signal whose timing wanders. GM's Corvette dual-clutch software derives the rod 4 sensor frequency from its period and expects 1500 to 2500 Hz; leaving that window for 150 ms stores a Type A fault, and the check is skipped while cranking or with reference B out of tolerance. Ford's 2024 summary books the frequency test of TR9070 rod sensor 4 under P2844. Mercedes-Benz lists no intermittent code for fork D in its 8G-DCT set; it only has the electrical code P2840 and the malfunction code P2841 for this sensor. Because fork D shares the even shaft and reference B with fork C on the Corvette, checking whether P283F is stored as well helps separate a common harness section from a single sensor. Expect sporadic shift hesitation and a lamp that may go out again.
Possible causes
- Chafed or loose harness section shared with the fork C sensor high
- Intermittent terminal contact at the fork D sensor medium
- Sensor with an unstable output frequency low
Symptoms
- Sporadic hesitation on shifts
- Warning lamp that may go out again
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2844
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.