OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2843

Shift Fork D Position Circuit High

P2843 means the fork D position line is sitting near supply level. GM's 2023 Corvette table raises it for rod 4 when there is no pulse activity and more than 3.5 V on the pin, or when the duty cycle is above 92 %; after a 150 ms confirmation a Type A code is set. The monitor is held off while P0652 or P0653 report a reference B problem and whenever battery voltage leaves the 8.75 to 18 V band, which keeps low-voltage starts from producing false entries. Ford's TR9070 counterpart is a rod sensor 4 signal held at logic one with too long a pulse, and in Mercedes-Benz's 8G-DCT list P284300 describes a positive short of the fork D sensor. A signal wire in contact with a feed or an open sensor ground is the likely cause.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 43

Possible causes

  • Fork D signal wire in contact with a feed wire high
  • Open ground circuit of the fork D sensor medium
  • Internal short in the sensor pulling its output high low

Symptoms

  • Fault message and warning lamp
  • Some even gears no longer selected
  • Limp-home operation

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2843

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication