OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2841

Shift Fork D Position Circuit Range/Performance

P2841 indicates that fork D reports a believable voltage but an implausible position. GM's 2023 table runs the rod 4 consistency test in the Corvette only when neither the even-clutch speed signal nor the output speed signal has shown an electrical fault for at least 100 ms, so the comparison has trustworthy speeds behind it. During engagement the sensor must reach the learned engaged point within 1100 µm once over 600 N push the rod; during release, a rod that stays within 1000 µm of its starting point counts against it. Type A, with a recovery attempt on the even shaft synchronizer. Ford's 2024 summary uses P2841 for TR9070 rod sensor 4 consistency and P277F for its drift, and Mercedes-Benz names it a fork D sensor malfunction on the 8G-DCT.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 41

Possible causes

  • Rod 4 or its synchronizer sticking so the fork lags behind the command high
  • Outdated learned positions after a clutch or sensor replacement medium
  • Fork D sensor or magnet shifted in its mount medium

Symptoms

  • Hesitation or repeated attempts on even-gear shifts
  • Gear not held, slipping back to neutral
  • Warning lamp with reduced gear range

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2841

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication