OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2840

Shift Fork D Position Circuit

P2840 is the overall circuit code for the shift fork D position input. Mercedes-Benz is the one maker that publicly documents it: in the 8G-DCT (transmission 724.1) of its compact models, P284000 marks an electrical fault of the fork D sensor, and the gearbox has a fifth fork E with its own codes from P2863 upward. The other two published dual-clutch strategies skip this code. GM's Corvette software treats fork D as rod 4 on the even shaft and reports its electrical faults as P2842, P2843 or P2844, and Ford's TR9070 summary does the same for rod position sensor 4. With the position of fork D unknown, the module cannot confirm whether its gear is in or out and normally withholds those ratios until the fault is gone.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 40

Possible causes

  • Electrical failure of the fork D position sensor high
  • Damaged wiring between fork D sensor and the TCM medium
  • Transmission control module input or software fault low

Symptoms

  • Gears of fork D withheld, gearbox skips them
  • Transmission warning lamp
  • Reduced driving comfort in emergency mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2840

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication