OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P283F

Shift Fork C Position Circuit Intermittent

P283F stands for an unstable fork C position signal rather than a hard short or open. The rod 3 sensor in GM's Corvette dual-clutch gearbox runs at a carrier between 1500 and 2500 Hz; if the measured period puts it outside that band for 150 ms, the module records a Type A fault, as long as reference B and battery voltage are valid. Ford's TR9070 summary assigns the frequency check of rod sensor 3 to this code. Mercedes-Benz does not list it for the 8G-DCT, and Ford's DPS6 has no fork C at all. Because the signal survives most of the time, the cause is usually mechanical stress on the wiring: a connector that moves with engine rocking, corrosion on a terminal or a cracked insulation near hot parts. Shifts may falter only now and then.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / 3F

Possible causes

  • Fork C connector working loose under engine movement high
  • Corroded terminal causing signal dropouts medium
  • Cracked insulation near hot components letting noise in low

Symptoms

  • Occasional stutter or delay on even-gear shifts
  • Warning lamp appears only now and then

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P283F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication