P283E
Shift Fork C Position Circuit High
P283E is the high-side fault of the fork C circuit. GM's 2023 summary checks the Corvette rod 3 sensor for two signs: no pulses at all with the pin above 3.5 V, and a duty cycle above 92 %. Either one, held for 150 ms with reference B in its 4.5 to 5.5 V window and the engine not cranking, stores a Type A code. Ford lists P283E for TR9070 rod sensor 3 as a pulse width beyond the upper limit, input stuck at one. Mercedes-Benz uses P283E00 on the 8G-DCT for a fork C sensor with a short to positive. In practice a pinched harness where the signal touches a feed, water in a connector bridging pins, or a sensor that has lost its ground are the usual finds. Fork C gears stay unavailable until the circuit is repaired.
Possible causes
- Pinched harness with the fork C signal touching a feed wire high
- Water in the connector bridging signal and supply pins medium
- Fork C sensor without ground connection low
Symptoms
- Warning lamp and gearbox fault message
- Fork C gears locked out
- Jerky driving in the substitute program
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P283E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.